Categories

How to configure light control box:

You are here:
< All Topics

Introduction

In this tutorial, I will go through different steps to configure light control box. First, you need to install the light control, then configure it on the system.

Configuration

  • Step 1: Install the light control on the network, it should be the same network as the server. You use internet cable to install it. You could connect it directly to the switch or to the computer directly. SMS-Timing recommends the following light control box LightControl Velleman.
  • Step 2: set the correct Ip address it should be the one on the screens of the light control box.

  • Step 3: Configure the lights to be turned on/ off using light control settings as in the picture below:

Leave a Reply

This site uses Akismet to reduce spam. Learn how your comment data is processed.