Categories

Configure the Mylapse AMB network settings

You are here:
< All Topics

In order to get the AMB decoder working with the SMS-Timing system, the device(s) need to be able to communicate with each other. Following steps wil guide you through the process.

  1. press the arrow button to go into settings.
  2. navigate to network with the arrow button and confirm with the dot button
  3. Make sure the “Automatic option” is off.
  4. navigate to IP address with the arrow button and confirm with the dot button
  5. configure the IP address.
    1. use the arrow button to move position
    2. use the dot button to increase the number. (number will reset after reaching maximum)
  6. save the IP address
  7. navigate to “subnet mask” with the arrow button and confirm with the dot button
  8. configure the “subnet mask”.
    1. use the arrow button to move position
    2. use the dot button to increase the number. (number will reset after reaching maximum)
  9. save the “subnet mask”
  10. navigate to “gateway” with the arrow button and confirm with the dot button
  11. configure the “gateway”.
    1. use the arrow button to move position
    2. use the dot button to increase the number. (number will reset after reaching maximum)
  12. save the “gateway”
  13. exit settings
  14. restart the decoder
  15. restart the “SMS-Timing reader module“.

This site uses Akismet to reduce spam. Learn how your comment data is processed.